(usagi-users 00614) Re: problems with usagi-kernel

[<6bone@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx>]

Hello,

sorry, there was a mistake at my side. All works fine :-)

But I have a other question:
If I try to ping all IPv6 nodes at the network I do 'ping6 ff02::1'
It works at bsd/kame systems but the linux/usagi ping6 reports

usagi/ping6/ping6 ff02::1
ping6: connect: Invalid argument

Can you fix that ?

MfG
Uwe

On Wed, 4 Jul 2001 6bone@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx wrote:

> Hello,
>
> I am using the newest usagi kernel and the the hosts all works fine.
> But if I try the setup a linux box with usagi kernel as a bridge I get
> some problems.
>
> ifconfig eth0 up - works without any errors, but
> ifconfig (without paramteters) do not show any interface
> the same with any other network interface (NC's, loopback and bridge
> device). I also can not use the network.
>
> Are there any problems with usagi/bridge mode known ?
>
> Thank you for your effors
> Uwe
>
>